dspConduct

Post a Request

A Role Processor with the Post role type can post a request to a target system.

NOTE: Credentials must be detected to post data. The Credentials Detected check box on the Request Group Post page must be enabled. If it is disabled, set credentials. Refer to Add Stored Credentials as a User on a Page in Integrate for more information.

Refer to Post a Request Overview for general information.

To post a request in dspConduct™:

  1. Click dspConduct > Requests in the Navigation pane.
  2. Click the Roles icon for a request.
  3. Click the Tasks icon for the post role.
  4. Click Request Post.
  5. Click the Group Post icon on the Request Group Post page to run each posting process listed on the Request Post Process page
  6. Click the Post icon for a process on the Request Post Process page.
  7. A confirmation message displays; click OK.
  8. After the Posting Status updates to Success or Failure, click the Message icon for each process to view details.

NOTE: A Designer can configure users to receive workflow notifications when the posting status is updated to Success or Failed. Refer to Send Workflow Notifications when a Post Fails or Succeeds for more information.

Continue with Finish a Role with the Post Role Type.