System Administration

Configure Bulk Execution

Bulk Execution allows a user to validate all records or a subset of those records on a DSP® page via a simple, guided user experience.

A Page Designer can enable Bulk Execution on a Construction page or a page in a custom WebApp. Refer to Enable Bulk Execution for a Page for more information.

Some pages in the DSP are delivered with Bulk Execution enabled.

Bulk Execution can also be run via a public WebApp event. Refer to the Knowledge Base article on the Support site called Bulk Execution Developer Guide for more information.

The Bulk Execution process only runs for the records that are accessible by the user as determined by that user’s security settings.

If a record is read-only, the record is not included in the Bulk Execution process. When Bulk Execution completes, read-only records display on the Results tab under the label Record was skipped during execution.

This section includes the following topics:

• DSP® Pages Delivered with Bulk Execution Enabled
• Enable Bulk Execution for a Page
• Create an OnValidate Page Event for Bulk Execution
• Configure Business Rule Settings
• Set Bulk Execution Parameters